There isn't a guide to tell us what AC unit is on your trailer so you would need to either determine the brand and model number or measure the shroud in order to find the correct storage cover. For example, the Adco RV Air Conditioner Cover # 290-3026 you were looking at is 37" long x 26" wide x 13-1/2" tall and fits the following units:
Coleman Mach 15, Coleman Mach 111 Plus, Coleman Mach 1 Power Saver, and Coleman Mach 111 Power Saver AC units.
If you don't know what model your unit... view full answer...
The referenced cover fits trailers 28'-6" long, and this trailer is 28'-9" long = 3" too short. I would go with the Adco # AD27ZR which is the next size up. Being slightly oversize will make it easier to put on as well. Zippered panels allow access to the interior as well. Adco makes good stuff. view full answer...
You can definitely swap up to a higher BTU rating for a more efficient system. You'll just want to first verify what style connector your Dometic rooftop unit has, whether it's a 6-pin or 9-pin connector. You can find the wire harness by removing the cover of your air distribution box to looking for the wire harness that hangs down and plugs into the controller.
If you have a 6-pin connector then you'll need one of the following units:
White # FR58PR
Black # FR86PR
If you have a 9-pin... view full answer...
Thanks for the information!
To replace the front cover on your Lippert Edge awning you need one of the following depending on if it's the drive or idler head:
- Edge Drive Replacement Front Cover # LC32NJ
- Edge Idler Replacement Front Cover # LC37UD
If you end up needing to replace the back as well then you'll need the following:
- Edge Drive Replacement Rear Cover # LC43UD
- Edge Idler Replacement Rear Cover # LC73UD view full answer...
Solar panels like the Go Power Solar Elite Charging System # 34282184 that you referenced can attach to curved roofs but the trick is to use longer and shorter mounting brackets so that the panel attaches while still being flat to the curved roof.
The brackets that come with this kit are all the same size so you may have to come up with a way to fabricate a way to make them shorter and taller. view full answer...
The camera frc12ta-bl is a Furrion Vision S camera like what comes with the kit part # FOS43TASF. This would give you a great camera and monitor setup that comes with a 4.3 inch screen. For a bigger screen the part # FOS05TASF comes with a 5 inch screen. view full answer...